BMW Control Arm (Wishbone) - Lemforder OE Quality with Pressed-In Bushing & Ball Joint

Overview

OE-quality suspension control arm (wishbone) from Lemforder, the No.1 OE supplier for BMW steering and chassis components. Includes pressed-in bushing and ball joint for direct replacement installation. Fits multiple BMW 3-Series generations (E90, E92, E93, F30) across 2006–2013 model years with various engine options. Lemforder parts are engineered to OE standards and often manufactured on the same production lines as genuine BMW components.

Installation summary

Replacing this front suspension control arm requires intermediate DIY mechanical skills and about two hours of work for an experienced enthusiast equipped with proper spring perch tools and standard garage equipment. Because this Lemforder unit arrives pre-loaded with a pressed-in bushing and ball joint, installation is a straightforward bolt-in procedure, but it is critical to torque all suspension fasteners only while the vehicle’s weight is fully resting on its tires to prevent premature bushing failure. If your BMW is equipped with aftermarket coilevers, you should also note your ride height measurements and make any necessary adjustments before completing the job. A professional four-wheel alignment is strictly required immediately following the installation to ensure proper handling and prevent uneven tire wear.

AI-generated overview — always verify against the official install instructions.